Alfano Lambda Sensor + Weld In Socket

Alfano Lambda Sensor + Weld In Socket

Alfano Lambda Sensor + Weld In Socket

Alfano Lambda Sensior including weld in socket 30cm
 
LAMBDA Sensor - enables tuning lights mode
The optimal value of carbaration is obtained between 85 to 90 (higher power). A value in the range of 1.10 is a mixture too lean. 

This sensor will help you tune your engine to produce the ideal power throughout the race. This sensor must be used with an extension cable of type "K".

T.A2501

Online only

$265.00 INC GST.

Add to cart

By buying this product you can collect up to 265 loyalty points. Your cart will total 265 points that can be converted into a voucher of $13.25.

More info

INSTALLATION

The temperature sensor (LAMBDA) must be positioned in the output of the engine exhaust gas,
at an approximate distance: 100-150mm (3.93/5.9inch)
1) Drill a hole with a diameter of 18mm (0.70inch).
2) Solder the nut provided
3) Fix the sensor with a 22mm spanner (do not tighten too hard)

WARNING: During installation, take care to remove the wire of this sensor from the other cables,
mainly of the type: RPM, high tension ignition system, in order to avoid mutual interference.

Accessories

  • Alfano 6 1T Data Lo...

    Alfano presents its new Alfano 6 data acquisition system. A concentrate of technology and reliability at the service of the amateur driver to the professional. From...

    $800.00 Add to cart
  • Alfano 6 2T Data Lo...

    ALFANO 6 2T  (2 Temperature Ports) - Available with Head Temperature Sensor or Water Temperature Sensor This unit is supplied with only 1 sensor please choose your...

    $900.00 Add to cart